Model | RG-AP630(IDA2) |
Target Deployments | For big campus, wireless city, harbour, storage room, mine |
Basic Specifications | Radio | Concurrent dual-radio dual-band |
Protocol | 802.11a/b/g/n/ac Wave2 |
Operating Bands | 802.11b/g/n: 2.4GHz to 2.483GHz |
802.11a/n/ac: 5.150GHz to 5.350GHz, 5.47GHz to 5.725GHz, 5.725GHz to 5.850GHz |
(vary depending on countries) |
Antenna | Built-in Directional Smart Antenna (support external/internal antenna switching) |
|
|
|
Antenna Loba Orientation | Internal Directional: Horizontal 60 degrees,Vertical 30 degrees |
Antenna Gain | 10dBi |
Max Throughput | Build-in antenna model: 800Mbps@2.4G |
1733Mbps@5G |
2.533Gbps per AP; |
External antenna model: |
600Mbps@2.4G |
1300Mbps@5G |
1.9Gbps per AP |
Spatial Streams | 4 |
Modulation | OFDM: BPSK@6/9Mbps |
QPSK@12/18Mbps |
16-QAM@24Mbps |
64-QAM@48/54Mbps |
DSSS: DBPSK@1Mbps |
DQPSK@2Mbps |
CCK@5.5/11Mbps |
MIMO-OFDM: BPSK, QPSK, 16QAM, 64QAM and 256QAM |
Receiver Sensitivity | 11b: -99dBm(1Mbps), -93dBm(5.5Mbps), -90dBm(11Mbps) |
11a/g:-93dBm(6Mbps), -85dBm(24Mbps), -82dBm(36Mbps), - 77dBm(54Mbps) |
11n:-92dBm@MCS0, -73dBm@MCS7, -92dBm@MCS8, -73dBm@MCS15 |
11ac HT20: -90dBm (MCS0) , -63dBm (MCS9) |
11ac HT40: -85dBm(MCS0) , -60dBm (MCS9) |
11ac HT80: -82dBm(MCS0) , -58dBm (MCS9) |
Maximum Transmit Power | 27dBm |
Note: The transmit power is configurable to up to 15dBm in 1dBm steps. The actual transmit power depends on local laws and regulations. |
Adjustable Power | 1dBm |
IP Rating | IP67 |
Ports | Service Port | One 10/100/1000Base-T Port（ETH1/PoE IN)；One 10/100/1000Base-T Port(ETH2)； |
One 1000M SFP Port(Combo Port) |
Management Port | 1 Console Port(RJ45) |
Power | Power Supply | PoE+ (802.3at) |
Power Consumption | <25W |
WLAN | Maximum clients per AP | Up to 512 |
SSID capacity | Up to 16 per radio |
Up to 32 per AP |
SSID hiding | Support |
Configuring the authentication mode. Encryption mechanism and VLAN attributes for each SSID | Support |
Remote Intelligent Perception Technology (RIPT) | Support |
X-speed | Support |
Intelligent load balancing based on the number of users or traffic | Support |
STA control | SSID/radio-based |
Bandwidth control | STA/SSID/AP-based speed control |
Preference for 5GHz (band select) | Support |
Wireless position tracking | Support |
Dynamic Frequency Selection(DFS) | Future Release Support |
Security | PSK, Web, and 802.1x authentication | Support |
Data encryption | WPA (TKIP) , WPA2 (AES), WPA-PSK, and WEP (64 or 128 bits) |
QR code authentication | Support |
SMS authentication | Support |
PEAP authentication | Support |
Data frame filtering | Whitelist, static/dynamic blacklist |
User isolation | Support |
Rogue AP detection and countermeasure | Support |
Dynamic ACL assignment | Support |
WAPI | Support |
RADIUS | Support |
CPU Protection Policy (CPP) | Support |
Network Foundation Protection Policy (NFPP) | Support |
Wireless Intrusion Detection System(WIDS) | Support |
Wireless Intrusion Prevention System (WIPS) | Support |
Routing | IPv4 address | Static IP address or DHCP reservation |
IPv6 CAPWAP tunnel | Support |
ICMPv6 | Support |
IPv6 address | Manual or automatic configuration |
Multicast | Support |
Management and Maintenance | Network management | SNMP v1/v2C/v3, Telnet, SSH, TFTP, and web management |
Visualized wireless heat map analysis | Support |
(need to integrate with SNC) |
Real-time spectrum analysis | Support |
(need to integrate with SNC) |
Fault detection and alarm | Support |
Cloud AC management | Support |
Statistics and logs | Support |
FAT/FIT switching | The AP working in FIT mode can switch to the FAT mode through the RG-WS wireless AC. |
The AP working in FAT mode can switch to the FIT mode through a local console port or Telnet. |
External Characteristics | Lock | Support |
LED Indicators | Power status and WDS signal strength |
Relevant Standard | Wi-Fi Alliance Certification | Support |
Safety Standard | GB4943, , EN/IEC 60950-1, EN/IEC 60950-22 |
EMC Standard | GB9254-2008, EN301 489, EN55022 |
Health Standard | EN 50385, |
Radio Standard | FCC Part15,EN300328, EN301893 |
Vibration Standard | GB/T 2423 |
Specifications | Dimensions (W x D x H) (mm) | 276 × 246 × 90 |
Weight | <2.5kg |
Work Environment | Temperature | Operating Temperature: -40°C to 65°C (heater module will be enabled at -15°C) |
Storage Temperature: -40°C to 85°C |
Humidity | Operating Humidity: 0% to 100% (non-condensing) |
Storage Humidity: 0% to 100% (non-condensing) |
Installation Mode | Wall/pole-mount installation |